The 150mm below DPC regulation is stipulated to prevent ‘splashback’ of moisture (ie rainwater hitting the ground and ‘splashing’ back up over the DPC. It is highly unlikely that having a DPC only 60mm above external ground level will have any detrimental effect on your property.
What is thickness of DPC? The DPC should be of 40mm thickness and should be of uniform thickness. It should not be provided at the locations of the door openings. The top level of DPC should match with the planned finished floor level.
Similarly, Can DPC be higher than 150mm? As long as the Dpc is a minimum of 150mm from the ground, you can step the dpc as much as you like. However, the dpc on the internal wall, should be level all the way round to match the existing dpc level.
Should air bricks be above or below DPC?
Air bricks may be located either above or below DPC level and where possible on all sides of the building. Ideally air bricks should be located at least 75 mm above hard and soft landscaped areas to reduce the risk of being obstructed or flooded (see diagram 1).
Is it OK to slope patio towards house?
Draining towards a building
Whenever possible, a pavement should slope away from a building. This is done to prevent surface water ‘hanging’ against the masonry of a building, which could lead to problems with damp.
Which grade of concrete is used for DPC at plinth level?
Solution(By Examveda Team)
Cement concrete of grade M15 (1:2:4) is used at plinth level.
What are the types of DPC? Types of Damp Proofing Course
- Electro-Osmotic Damp Proof Course.
- Chemical Damp Proof Course.
- Pressure Grouting.
- Membrane Damp Proof Course.
- Integral Damp Proof Course.
- Cavity Wall Damp Proof Course.
How DPC is done? A damp-proof course (DPC) is a barrier through the structure designed to prevent moisture rising by capillary action such as through a phenomenon known as rising damp. Rising damp is the effect of water rising from the ground into property. The damp proof course may be horizontal or vertical.
Can DPM be higher than DPC?
No you can not put the dpm above the damp course as you will be bridging the damp course. … You need to protect the bricks above the damp course and below the dpm to stop the damp rising.
Can you put gravel above DPC? A land drainage pipe, usually a perforated plastic type, is laid at the base of the channel, connected to the SW drainage system at a convenient point and covered with a clean gravel to a level no higher than the dpc. The walling may be protected by a drainage composite or tanking.
Can engineering bricks be used as a DPC?
Engineering bricks can be used as a rigid DPC. This consists of two or more courses of Class A engineering bricks. This type of brick has the lowest absorption of any clay brick produced in the UK, which means it is very resilient to rising damp.
Do you need a cavity tray at DPC level? There isnt normally a cavity tray at dpc level, unless in instances where the likes of a Radon Barrier is required, which should overlap inner wall, cavity and outer wall. You would then need a cavity tray above with weep holes.
Do air bricks stop damp?
Under no circumstances install air vents or air bricks to assist with condensation; the short answer is : they will make it worse !
Should patio be sloped?
The patio must be perfectly level, and it shouldn’t have any irregularities, dips or bumps. Making the patio flat isn’t the same as making it level. If the patio is perfectly level then pools of water will remain on it after rain or spraying it clean. The patio should therefore always have a slight slope.
Should patio be level or sloped? A patio should slope away from the house at the rate of 1/8″ (3mm) per running foot. Generally, a 4″ (100mm) thick slab set 2″ (50mm) above ground level is suitable. To ensure that the height and slope are correct, begin the excavation, layout and form construction where the patio meets the house.
Does paving need drainage?
What subsurface drainage do you need under a permeable pavement? A good permeable pavement should drain significant quantities of water immediately through both the paving layer and paving base. This means that in all but the heaviest of rain events, very little water remains on the surface of the paving.
How the DPC materials can be classified?
DPC materials can be classified into 3 categories. The categories are flexible materials, semi rigid materials and rigid materials.
What is the most commonly used material for DPC? Rich Concrete is the most commonly used material in DPC. Usually, rich concrete in the proportion 1:2:4 that is painted with two relative coats of hot bitumen is used for the horizontal damp proof course.
When DPC is to be laid over large areas the material preferred is?
2. DPC Material for floors, roofs etc. For greater wall thickness or where DPC is to be laid over large areas such as floors, roofs, etc., the choice is limited to flexible materials that provide a lesser number of joints like mastic, asphalt, bitumen felts, plastic sheets, etc.
How is DPC measured? Damp proof course about 25 mm thickness in cement concrete (1:1.5:3 or 1:2:4) combined with standard water proofing agent is applied evenly to the entire width of plinth level and is measured by multiplying the length of the D.P. course by its width in square metres.
What’s DPC?
A damp proof course (DPC) is a form of damp proofing installed in a property to prevent rising damp and associated problems.
What is full form DPC? Damp Proof Course (DPC)